Asante-technologies ASANTE MacCon Family Ethernet Network Cards for th Manual de usuario descargar pdf (Pagina 23)

Installing Asanté MacCon Cards 2-13

Installing the MacCon3 IIsi and MacCon 30i Cards

If you have a Macintosh IIsi or a Macintosh SE/30, use a MacCon3 IIsi

or a MacCon+ 30i to connect to the Ethernet. (The cards are not

designed for a Macintosh SE.)

Each card consists of two parts:

❏ The larger controller card, which plugs into the expansion

slot in the Macintosh.

❏ The smaller daughter card, which is mounted on the rear

access port to enable a connection to the Ethernet cable.

You connect the two cards with a ribbon cable after installing them.

Setting the Cable Type on the Daughter Card

With the MacCon+ 30iET and MacCon+ 30iE, set the cable type by

pressing the switch in the lower left corner on the daughter card.

Select the switch position, as speciﬁed in the table below, by press-

ing the switch with a pointed tool. With the MacCon+ 30iET, select

TPL if your hub supports link integrity; select TPN if it does not.

The MacCon3 card has autosensing ports and does not require a

switch to be set.

MacCon+ 30iET MacCon+ 30iE

TPL 10BaseT

Link integrity enabled

TPN 10BaseT

Link integrity not enabled

TK Thick

TN Thin

TK Thick

TPL

TPN

Switch

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 64 65

Sin comentarios

Asante-technologies ASANTE MacCon Family Ethernet Network Cards for th Manual de usuario Pagina 23